MP6653AGDTE

35V, 1.2A, Single-Phase BLDC Motor Driver with Integrated Hall Sensor and MOSFETs in a Wettable-Flank TQFN-6 (2mmx3mm) Package

详情

The MP6653AGDTE is a single-phase, brushless DC (BLDC) motor driver with integrated power MOSFETs and an embedded Hall sensor. It can achieve up to 1.2A of peak coil current across a wide 3.5V to 35V input voltage (V_IN) range.

The pulse-width modulation (PWM) signal or the DC voltage (V_DC) applied on the PWM pin controls the motor speed. The device also features soft commutation, a configurable Hall offset angle, and a configurable speed curve.

The FG/RD pin is an open-drain output that can be configured for speed detection (FG) or locked rotor detection (RD). It can detect the speed based on the embedded Hall-effect sensor’s output, and a locked rotor if locked-rotor protection is triggered.

Rich protections include input over-voltage protection (OVP), under-voltage lockout (UVLO), locked-rotor protection, over-current protection (OCP), and thermal shutdown.

The MP6653AGDTE is available in a wettable-flank TQFN-6 (2mmx3mm) package.

产品特性和优势

Wide 3.5V to 35V Operating Input Voltage (V_IN) Range
On-Chip Hall Sensor
Integrated Power MOSFETs: Total 960mΩ for the High-Side MOSFET (HS-FET) and Low-Side MOSFET (LS-FET)
Selectable Open-Loop or Closed-Loop Speed Control
Configurable Speed Curve
Configurable Start and Stop Duty Cycle
Soft-On and Soft-Off Commutation
Configurable Soft Acceleration Time
Configurable Hall Leading/Lag Angle
50Hz to 100kHz Pulse-Width Modulation (PWM) Input Frequency or DC Input
Automatic Reverse Current Block
24kHz PWM Output Frequency
Configurable Current Limit
Short-Circuit Protection (SCP)
Over-Voltage Protection (OVP)
Standby Mode
Selectable FG or RD Output
Available in a Wettable-Flank TQFN-6 (2mmx3mm) Package

正在供货产品型号

MP6653AGDTE-xxxx-Z MP6653AGDTE-xxxx-P MP6653AGDTE-0000-Z MP6653AGDTE-0000-P

P&Z的含义

相关产品

MP6653AGJ 35V, 1.2A, Single-Phase BLDC Motor Driver with Integrated Hall Sensor and MOSFETs in TSOT23-6-SL and TSOT23-6 Packages

The MP6653A is a single-phase, brushless DC (BLDC) motor driver with integrated power MOSFETs and an embedded Hall sensor. It can achieve up to 1.2A of peak coil current across a wide 3.5V to 35V input voltage (V_IN) range.

Rich protections include input over-voltage protection (OVP), under-voltage lockout (UVLO), locked-rotor protection, over-current protection (OCP), and thermal shutdown.

The MP6653AGJL is available in a TSOT23-6-L package, and the MP6653AGJS is available in a TSOT23-6-SL package.

¥12.39
+ 税

MPQ6653AGDTE-AEC1

集成霍尔传感器的35V/1.2A、单相 BLDC 电机驱动器，采用 TQFN-6 (2mmx3mm) WF 封装，符合 AEC-Q100 认证

MPQ6653AGJ-AEC1

集成霍尔传感器的35V/1.2A、单相 BLDC 电机驱动器，采用 TSOT23-6-SL或TSOT23-6 封装，符合 AEC-Q100 认证